Run Car on Water - How to Make your own Distiller Water

Want to optimized the performance of “Water for fuel” kit and gain the bigger saving from run car on water? The best option is to use Distiller water instead. Based on feeback, it ill boost Miles Per Gallon (MPG) performance in all cars by as much as 70%, but more realistically 25%-50% expected.

Here’s how you can build a solar water distiller with the materials can be normally found around the home:
1. Take a bucket or a big plastic bowl, fill it ¾ with tap water, and place a large cup in the center of the bucket, above water level. Suspend the cup with some tape or wire so it stays afloat at the center of the bucket.
2. Put any type of plastic wrap or thin plastic sheet (preferably clear or transparent) over the top of the bucket.
3. Put a stone or some other weight at the center of the plastic wrap, on top. It should be just heavy enough to bend down the wrap and form an inverted cone. The tip of the cone should be pointed directly into the cup inside the bucket.
4. Place this contraption in the sun for a few hours. The water will start to evaporate and its vapor will condense on the plastic wrap. The condensed water will drip down the cone you’ve created - and fall right into the cup. This is distilled water.
IMPORTANT NOTES : DO NOT DRINK THIS WATER. The warm plastic leaves microscopic particles not
good for human consumption. Yet this distilled water is perfectly good to run a car with this water!!!