The 1st commercial water powered car (power by Hydrogen) is here! Honda has begun the first commercial production of a zero-emission, hydrogen fuel-cell powered vehicle. Honda FCX Clarity is a four-seated hydrogen vehicle that runs on electricity produced by combining hydrogen with oxygen, and emits water vapour.

Good News: This car is 3 times fuel efficient as compare to the petrol-powered car.

Bad News: Honda plans to produce 200 of the cars over the next three years. It will be hard for you to see it on the road or even own it!

How the Honda Hydrogen Cars works?

Picture from BBC News

Many car makers are developing cleaner, more economical vehicles because of high fuel prices and as consumers become more concerned with the environment. But, it will take them long time to develop it due to the high material cost.

To ensure you are able to cope during this difficult period especially the gasoline price have jump up to $4 per gallon. You should seriously take a look on how to make a Hydrogen-on-Demand system to work with your traditional, petrol-powered car.

Water4Gas technology is easy and doable with limited skills. I will advise you go with something we all know can be done fairly easily, and where there are available products to buy.

Wonder how a “water for fuel” kit worked in a traditional car? You can check out this diagram to have an overview on how to convert your car in water powered car!

As you can refer to the figure that provided by Water4Gas, this is how they have built the kit to integrate with your car engine.

This kit is design with dual HHO supply out, the reason is that when the engine is idling, there is a high vacuum pressure in the intake manifold. This pressure drops when you accelerate the engine to higher RPM. At that moment, more vacuum is available in the air intake for sucking up the HHO gas into the engine. It will save a bit more gasoline.

With the Water fuel kits guide provided by them, you will be able to build a water powered car in a day and drive on the road with water!

Every system need to have proper maintenance, that included the “water for fuel” kit. To allow you to run car on water in your water powered car smoothly, some general maintenance guides are here for your reference.

Water level too Low

The immediate action is to add water. For safety’s reason, never do it with the electricity on.

1. Turn the ignition switch fully off AND pull the fuseout.

2. Never fill out new water into an empty HOT JAR. Let it cool first.

3. Do it weekly or bi-weekly refilling, prepare a gallon of distilled water with the proper amount of Electrolyte.

JAR Overheats

If your jar is overheated, you should lower the ratio of Electrolyte. At ¼ teaspoon, the unit will normally stay cold or lukewarm, and moderate amount of HHO will be produced.

Not too much worry about the jar, no “water powered car” owner reported that any jar cracking due to heat.

NO HHO Production

Check for a blown fuse.

If the fuse is OK, check the wiring. Measure the voltage between the terminals – it should read around 12 Volts.

Fuse keeps blowing? First check the wiring outside the device. Verify that nothing touches the body of the car or some other metallic or conductive element. Inspect the electrodes inside the device.

HHO Production too low

Try to replace the water. Maybe you or somebody else put distilled water and forgot the Electrolyte.

You no longer have to break your bank account for fuel expenses! With a water powered car, the massive annual savings from fuel costs and the healthy perks of a pollutant-free car will be yours.

Through the use of water combined with gas, you can boost up your mileage by 30 to 50%! Not to mention your engine’s life and power would be greatly lengthened. And the technology backing water powered cars are pretty simple and inexpensive.

This idea is NOT a new one. Cars running PURELY on water are still being tested and researched and it may take a long time before they’re publicly available. And there are 2 BIG reasons why.

First, the large oil companies and tycoons want to squeeze the last dime from the fuel industry. Second, manufacturing water powered cars in bulk would be very costly and not everyone would have the means to choose such an expensive option.

You can now convert your vehicle into a water powered car that combines the power of water and gasoline. And there’s no need to worry about getting your cars interiors and parts into trouble. Matter of fact, the use of water as alternative fuel enhances combustion which means there’ll lesser carbon and filth build up.

Get this – combustion with the usual gasoline has been proven to be destructive for automotive parts.

Now if a significant amount of it would be replaced with water, your motor will live a longer life and will wear down at an extremely slow pace. Water powered cars also operate in a more calm and nearly noise-free way.

Not to mention the trip to your destination will be way smoother than usual. You’re saving money not just on fuel costs BUT from repairs and replacement of you car parts as well.

Anybody, even those with zero technical knowledge, can convert their wheels to a water powered car, and it would NOT cost them more than $200! Why not give it a try? Your car and your pocket will surely love it!